1. 圣阳蓄电池具有优良的防酸及排气性能，当压力超过正常值时应可靠排气，压力恢复正常值时应可靠密封，无论在任何情况下应确保排出的气体不含酸雾；

2. 圣阳蓄电池容量应按国家规定的方法试验，10h率容量应在第一次循环不低于0.95C10，第五次循环应达到C10，放电终止电压应为1.8V。日自放电率小于额定容量的0.1％或月自放电率小于额定容量的4％；

3. 圣阳蓄电池应密封良好，无论立放或卧放均无电解液溢出；

4. 圣阳蓄电池采用组架安装,并安装于蓄电池室。圣阳电源厂家应标示每个蓄电池的序号和组别。

5. 圣阳蓄电池可以大电流放电，蓄电池以30I10的电流放电1min，极柱不应熔断，其外观不得出现异常；

6. 圣阳蓄电池静置90d后，荷电保持能力标准公式计算不低于80%，完全充电的蓄电池表面应清洁；

7. 圣阳电池密封反应效率：密封反应效率不低于95%。

1. Shengyang battery has excellent anti-acid and exhaust performance, when the pressure exceeds the normal value should be reliable exhaust, pressure to normal value should be reliable sealing, in any case should ensure that the discharged gas does not contain acid fog;

2. Shengyang battery capacity should be tested according to the national provisions of the method, 10H rate capacity should not be less than 0.95C10 in the first cycle, the fifth cycle should reach C10, discharge termination voltage should be 1.8V. The daily discharge rate is less than 0.1% of the rated capacity or the monthly discharge rate is less than 4% of the rated capacity;

3. Shengyang battery should be well sealed, regardless of vertical or horizontal electrolyte overflow;

4. Shengyang battery is installed by the group frame and installed in the battery room. Shengyang power supply manufacturers should mark the serial number and group of each battery.

5. Shengyang battery can large current discharge, battery to 30I10 current discharge for 1min, pole pole should not fuse, its appearance shall not appear abnormal;

6. Shengyang battery standing for 90 days, the charge retention capacity standard formula calculation is not less than 80%, fully charged battery surface should be clean;

7. Sealing reaction efficiency of Shengyang battery: Sealing reaction efficiency shall not be less than 95%.